Boost pressure sensor clogged - diesel VEA and latest D5 5-cyl.
2020-01-17
If you have diesel car with 5-cylinder engine from 2012 or newer, or you have 4-cylinder VEA engine, then you need to clean the boost pressure sensor every 30-80.000-km. Otherwise your engine power will rapidly decrease and you can expect the engine…
P2 CEM cover leak / P2 protékání vody na CEM
2024-09-12
První ročníky faceliftových P2 (V/XC70, S60, S80, XC90) - t.j. celý ročník MY 2005 a první týdny MY2006 - trpí problémem vnikání vlhkosti resp. vody do centrální jednotky CEM. Jedná se o výrobní vadu, často se projevujcí. A - pokud není preventivně…
Configuration changes - P3 cars
2020-07-11
For change configuration in P3 you need to decode CEM PIN via OBD with VDASH - how to do it is described here: https://d5t5.com/article/volvo-cem-pin-code This is applicable only for P3 cars: V40II / V40CC / S60II / S60CC / V60 / V60CC / XC60 /…
EGR blanking plate - Euro3 D5 - D5244T/D5244T2
2019-11-04
If you load EGR OFF software into Euro3 engine (D5244T (120kW) or D5244T2 (96kW)) with VDASH, you must install EGR blanking plate according the pictures below: You can buy the blanking plate in our e-shop.
Volvo diesel injectors codes and engine variants
2024-03-15
Injector part numbers according the Volvo platform and engine code Volvo platforms recognition is here: VOLVO platforms Some of those injectors requires coding the IMA codes or the injector class. Both can be done with VDASH or VIDA. P3 only …
P3 MY2012+ heated steering wheel
2024-12-14
How to retrofit heated steering wheel for all Volvo P3 SENSUS cars: Applicable for S80, V70, XC70, XC60 MY 2012+ and S/V60 MY 2013+ What you need: heated steering wheel HSWM module (heating unit for the steering wheel) - 31343460 SAS ring -…
Volvo P2 Keys and Remotes Explained
2024-03-13
Remote Keys and Ignition Keys in Volvo P2 vehicles Volvo platforms are described here: VOLVO platforms The ignition key and the remote control in Volvo P2 platform vehicles are separate, and essentially, they do not relate to each other at all.…
Programming modules in Volvo - can I 'kill it'?
2024-12-19
Programming modules in Volvo cars - is it possible to kill it during software loading? When power-up any Volvo electronic control module, the primary bootloader starts (PBL) for 20 ms (0.02 seconds). During this time the control module receive a…
Pairing SCU / SCL unit
2023-10-05
Preconditions IMMO code must present - for P3 cars it is automatically decoded when CEM PIN is present or successfully decoded. The SCU / SCL unit must be new virgin (blue box), used SCU / SCL from another car can't be used. Procedure Ignition…
VDASH FLAT Tariffs
2023-10-09
Unlimited VDASH FLAT Config and VDASH FLAT Ultimate Plans In VDASH, two new tariff categories are now available for specific VIN (one vehicle), differing in the scope of services/software included in the tariff price. The FLAT tariff is generally…
P2 MY 1998 - 2004 VDD - úprava CEM pro podporu commandu na vozech P2 MY2000 - MY 2003
2021-04-19
VDD bridge CEM relays To be able to turn on the independent heater, lock, unlock etc.... for Volvo P2 MY 1998 - 2004, you need to bridge the relay in the CEM which disconnects the OBD socket when the key is removed from the ignition.
VDASH support for iCUP / Android Volvo cars - diagnostics
2023-09-18
VDASH support for iCUP / Android Volvo cars - diagnostics The new generation of Volvo cars with the Android system (iCUP) comes equipped with state-of-the-art security features and an integrated firewall. This firewall is housed within a cutting…
How to appear on the MAP as a D5T5 dealer?
2020-06-22
If you wish to be visible as a dealer on the D5T5 map, all that it requires is you simply going to VDASH and change the settings to dealer. https://d5t5.com/dealers/ The map is updated once every 24 hours.
Volvo DiCE - update
2019-09-30
EN DiCE update VDASH works best with the latest Windows driver and the latest DiCE firmware. Both available for download: https://d5t5.com/sw/SetupDiCE.exe Update the DiCE firmware DiCE with SN 2xx.xxx to version 5.6.2 from: c:\Program Files\DiCE…
CANALT - VDD Support for SPA / CMA Volvos
2021-11-15
CANALT Wiring for SPA / CMA Volvos In order for the VDD to work properly on newer Volvo platforms (SPA and CMA), it needs access to the vehicle's low-speed CAN bus. This connection allows the VDD to: Check the status of doors, locks, and windows …
Authorizing a new computer in VDASH
2019-10-15
If you've come across this notification in the VDASH system then most likely there has been a hardware change in your computer, or you have gotten a new computer and all spots for VDASH hardware are full. You can authorize your new computer via…
Volvo abbreviations - zkratky
2022-11-17
Volvo abbreviations 2 VALVE 2 valves/cylinder 2VVT Double variable valve timing 2WD Two-wheel drive 4 VALVE 4 valves/cylinder 4C Continuously Controlled Chassis Concept 4CYL 4-cylinder engine 4DRS 4 door car…
SPA and CMA mileage manipulation
2025-02-28
Custom mileage manipulation of your Volvo SPA/CMA In new Volvo cars platform SPA and CMA is implemented advanced milage synchronization across entire car (all modules), therefore if someone has and idea to swap instrument cluster (DIM) for another…
IHU Engineering Mode - change region settings P3
2020-01-17
After you have changed the region settings in car configuration (for example the USA market to EU), you also need to change the region settings in the entertainment system. If you do not do this the entire infotainment system will be extremely slow…
Jazyk
2018-11-25
Custom language for your Volvo is easy and without limitations with us! Unlike official dealers, we are not limited by model years or other aspects but only by the vehicle's hardware capabilities. This allows us to offer Czech language support…
VDASH and Language Change in Your Volvo
2026-04-17
Modern Volvo vehicles are known for their advanced software-driven architecture, which allows many features to be configured digitally rather than mechanically. One of the most practical examples of this is the ability to change the vehicle’s…
TFT retrofit
2019-05-23
TFT DIM Retrofit - A platform for series P3 (S/V60, XC60, S80II, XC/V70III) All older platforms - P3 are all equipped with the older version of the instrumental board. (DIM) or These vehicles can be modernized and equipped with much more modern…
XC90 LED Tail lights upgrade - MY2006+
2020-06-15
This is a quick tutorial on how to upgrade rear/tail lights for Volvo XC90s to LED lights, so you can go from this: to this: You will need: - LED lamps :)- your car must be MY2006 and above- the latest REM software- CEM configuration with VDASH: …
SRS-CFFF / CFFF Fix
2019-09-30
SRS-CFFF Very common fault for Volvo P1 cars (C30 / S40II / V50 / C70). The official way to fix this error is to replace the SRS unit by a Volvo dealer for approximately €800. VDASH can fix this error via OBD without any harm to the airbag system…
Sensus - Navigation conversion US>EU MY2012-2014 (old sensus without globe key)
2020-06-23
If you want to convert your first generation Volvo Sensus (MY2012-2014 - without the globe key) navigation from USA market to Europe, then you need to load special conversion software via USB.Unfortunatelly, this service is not possible for now via…
Konfigurace
2018-12-30
Configuration - Vehicle Equipment Modification Each Volvo is manufactured according to predefined specifications. Some features can be added or modified at authorized Volvo dealers, such as: parking sensors, cameras, tow bars, cruise control,…
Activate fuel heater for P2
2020-03-02
How to activate the fuel heater using VDASH? You can do this using two different ways: A/ With the timer and additional heater - this option will display the timer in the menu, and the heater will begin to operate automatically once the outside…