I have problem with dtcs:
ECM-9A0A Vehicle behavior. Behavior 8
ECM-990F - Torque monitoring faulty signal.
Car had replaced ECU. The old one was burned and I can't clone it. I get only data from eeprom to another one.
What can be reason of this dtcs?
Can it be wrong software at ecu? vdash shows that softwaer is unmodified.
Your ECM firmware version does not appear to match the car.
Get ECM RELOAD to be loaded at an official Volvo dealer, then and only then you shall start diagnosing the car right.
VIN YV1MW664262XXXXXX
Model V50
Year 2006
Platform P1
This car was only connected to the question.
However, this is not a condition that this question and answer can only be applied to this car.