VDASH Guide

Cloning & Replacing a DIM on a P2

DIM cloning and replacement in vdash

When replacing a DIM (Driver Information Module) on a P2 Volvo, the correct procedure depends on the DIM generation and model year.

A DIM can be cloned only to another unit with the same hardware number. If the replacement DIM uses different hardware number, cloning is not possible.

MY2004 – Green Connector

MY2004 cars use the newer OL85D DIM with a green connector.

These units are not cloned. When a compatible replacement DIM is installed, VDASH automatically provides the required fix-up.

Green-connector DIMs are relatively uncommon because they were used for only a short period.

MY2005+ – White Connector

Later P2 cars use the OL85D DIM with a white connector.

These DIMs also use the VDASH fix-up instead of cloning.

If replacing an earlier green-connector DIM with a white-connector version, obtain the white connector together with its wiring. The wiring can then be connected alongside the original green connector.

In Short

  • Clone only to the same DIM hardware.
  • MY2004, green connector: Do not clone — use VDASH fix-up.
  • MY2005+, white connector: Do not clone — use VDASH fix-up.

The green and white connector versions are both OL85D LED DIMs; the main physical difference is the connector.

Note: The VDASH fix-up will appear automatically in the SOFTWARE box upon installing the correct DIM. Open the box and install the software patch.